sorry one last time
- Thread starter Mad skillz
- Start date
Well your deck should have a bunch of wires coming out the back, and two sets for your front and rear speakers,(not your sub pre-outs) or little clip things, pretty much it has a wire harness. connect them to that, and yes hopefully you have an amp. But the only thing that could really make your speakers lose power when it comes to wires is, bad connection, or too small of a guage wire.
Ok
From the cd player are the original wires into the door speakers. I cut that wire so the door speakers didn’t work any more. I then connected the original door speaker wires to a new wire that runs to my 6x9.
The new wire I think is only 1mm.
If I would to get a new wire that ran from my 6x9 to the original wire (which I would connect them together) would that make the sound quality better?
From the cd player are the original wires into the door speakers. I cut that wire so the door speakers didn’t work any more. I then connected the original door speaker wires to a new wire that runs to my 6x9.
The new wire I think is only 1mm.
If I would to get a new wire that ran from my 6x9 to the original wire (which I would connect them together) would that make the sound quality better?
If you run a new wire from Cd Unit to 6x9's that is off a larger thickness, you will get a better sound. If you are connecting to existing door speaker wires, then keep the same wire. New wire won't improve the sound.
You'd do best to run a set of RCA's from Pre-out on back of cd player into an amp in your boot. Then run a decent speaker wire from Amp to 6x9's. Takes more work, but gives you a better sound and also experience in car audio.
If I was putting a stereo in my car. I'd put mids and tweets in front doors and in back. Each speaker going through a crossover and into a 4 channel amp, connected to a decent stereo.
Then I'd run 2 10 inch subs. Connected to a bridged amp. in the boot. I'd sound deaden the whole car, and make sure I use high end equipment throughout. But that is just me.
Where did you cut the original wire, from the deck or where the speaker was. You should of just cut like an centimeter away from where they were connected to the speaker and connected them like that. Only because you are not using an amp. Wires and shit won't give you all kinds of sound quality, it will let you give them more power to run to the speaker, so if you want better sound quality get an amp.
no the cone its self(i think) like it moves with the bass.... if u look at a speaker you can see that it is moving(not cos it doesnt fit, but because it is ment to) this is what makes the sound. turn up some speakers in your house (not computer ones, well mine dnt neway) but some fairly good ones and you can see it move
you get what i mean?
you get what i mean?